|
Selecting Gear
Silicone
Tubing: Carry a range of floats that use the same size silicone float
caps. This allows for a quick change from one size of float to
another without having to cut and re-tie the line. Place an extra
float cap at the bottom of the float to hold the float firmly and act as
insurance in case one of the other float caps breaks off.
Swivels: Use a
RAVEN®
Ultra Micro Swivel to connect the leader line to the main line. This
is a stronger connection than tying a knot between the lines.
Additionally, a low friction barrel swivel helps reduce line twist from
the bait spinning during the retrieve. The smaller the swivel, the
less visible it will be, but make sure to use a size you can comfortably
manipulate.
Split Shots: Split shots are available in a variety of sizes, from
the tiny No.8 to the relatively hefty AAA, to match any rig. It is
important to carry a range of sizes to be prepared for any situation.
Split shot dispensers are a convenient way to carry a full range of shot.
A soft split shot, like Sure Shot, can easily be repositioned on the line
if conditions change, but may need to be adjusted occasionally. A
harder shot like
RAVEN®
Pro-Shot will not move once rigged, but offers less versatility in varying
water conditions.
TIP:
Use a variety of shotting patterns for every pool or run. Each
pattern presents the bait differently, allowing it to catch different
underwater currents and cover different depths. Covering these
different holding areas will maximize the catch out of any spot.
Prepare a variety of “shot lines” in advance to save time on the water.
A “shot line” is a length of low-vis line with a micro swivel at each end
to connect the leader to the main line below the float. The “shot
line” should be stronger than the leader line, but lighter than the main
line. Split shots are arranged along the line in a variety of
shotting patterns. The “shot line” can easily be switched on the
river when needed.
|
